Title

Symantec ProxySG must configure SNMPv3 so that cryptographically-based bidirectional authentication is used. (Cat II impact)

Discussion

Without authenticating devices, unidentified or unknown devices may be introduced, thereby facilitating malicious activity. Bidirectional authentication provides stronger safeguards to validate the identity of other devices for connections that are of greater risk. A local connection is any connection with a device communicating without the use of a network. A network connection is any connection with a device that communicates through a network (e.g., local area or wide area network, Internet). A remote connection is any connection with a device communicating through an external network (e.g., the Internet). Because of the challenges of applying this requirement on a large scale, organizations are encouraged to only apply the requirement to those limited number (and type) of devices that truly need to support this capability.

Check Content

Verify only SNMPv3 (which supports authentication) is configured on the Symantec ProxySG. 1. Log on to the Web Management Console. 2. Click Maintenance >> SNMP. 3. Ensure that only "Enable SNMPv3" is checked. 4. Click on "SNMPv3 Users" and ensure that a user exists in the list. If SNMPv3 (which supports authentication) is not configured or is not the only one configured on the Symantec ProxySG, this is a finding.

Fix Text

Enable only SNMPv3 (which supports authentication) on the Symantec ProxySG. 1. Log on to the Web Management Console. 2. Click Maintenance >> SNMP. 3. Uncheck "Enable SNMPv1" and "Enable SNMPv2c" and check "Enable SNMPv3". 4. Click on "SNMPv3 Users", click "New" and enter the desired username, credentials, and authorization settings, click "OK". 5. Click "SNMPv3 Traps", click "New", enter the IP address/FQDN for the SNMP receiver. 6. Click "OK", click "Apply".

Additional Identifiers

Rule ID: SV-104529r1_rule

Vulnerability ID: V-94699

Group Title: SRG-APP-000395-NDM-000310

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.