Title

The RUCKUS ICX multicast Designated Router (DR) must be configured to increase the shortest-path tree (SPT) threshold or set it to infinity to minimalize source-group (S, G) state within the multicast topology where Any Source Multicast (ASM) is deployed. (Cat II impact)

Discussion

ASM can have many sources for the same groups (many-to-many). For many receivers, the path via the RP may not be ideal compared with the shortest path from the source to the receiver. By default, the last-hop router will initiate a switch from the shared tree to a source-specific SPT to obtain lower latencies. This is accomplished by the last-hop router sending an (S, G) Protocol Independent Multicast (PIM) Join toward S (the source). When the last-hop router begins to receive traffic for the group from the source via the SPT, it will send a PIM Prune message to the RP for the (S, G). The RP will then send a Prune message toward the source. The SPT switchover becomes a scaling issue for large multicast topologies that have many receivers and many sources for many groups because (S, G) entries require more memory than (*, G). Hence, it is imperative to minimize the amount of (S, G) state to be maintained by increasing the threshold that determines when the SPT switchover occurs.

Check Content

Review the DR PIM configuration to verify that the SPT switchover threshold is increased (default is "1") or set to the maximum value. router pim rp-address 10.2.2.2 spt-threshold 4294967295 If the DR is not configured to increase the SPT threshold to minimalize (S, G) state, this is a finding.

Fix Text

Configure the DR to increase the SPT threshold or set to the maximum value to minimalize (S, G) state within the multicast topology where ASM is deployed. The maximum value is displayed in the example. ICX(config)# router pim ICX(config-pim-router)#spt-threshold 4294967295

Additional Identifiers

Rule ID: SV-273640r1110943_rule

Vulnerability ID: V-273640

Group Title: SRG-NET-000362-RTR-000123

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.