Title

The perimeter router must be configured to have Link Layer Discovery Protocols (LLDPs) disabled on all external interfaces. (Cat III impact)

Discussion

LLDPs are primarily used to obtain protocol addresses of neighboring devices and discover platform capabilities of those devices. Use of SNMP with the LLDP Management Information Base (MIB) allows network management applications to learn the device type and the SNMP agent address of neighboring devices, thereby enabling the application to send SNMP queries to those devices. LLDPs are also media- and protocol-independent as they run over the data link layer; therefore, two systems that support different network-layer protocols can still learn about each other. Allowing LLDP messages to reach external network nodes is dangerous as it provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

Check Content

This requirement is not applicable for the DoDIN Backbone. Review all router configurations to ensure LLDPs are not included in the global configuration or LLDPs are not included for each active external interface. Examples of LLDPs are Cisco Discovery Protocol (CDP), Link Layer Discovery Protocol (LLDP), and Link Layer Discovery Protocol - Media Endpoint Discovery (LLDP-MED). If LLDPs are configured globally or on any external interface, this is a finding.

Fix Text

This requirement is not applicable for the DoDIN Backbone. Disable LLDPs on all external interfaces.

Additional Identifiers

Rule ID: SV-207165r856650_rule

Vulnerability ID: V-207165

Group Title: SRG-NET-000364

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.