Title

RHEL 8 systems, version 8.4 and above, must ensure the password complexity module is configured for three retries or less. (Cat II impact)

Discussion

Use of a complex password helps to increase the time and resources required to compromise the password. Password complexity, or strength, is a measure of the effectiveness of a password in resisting attempts at guessing and brute-force attacks. "pwquality" enforces complex password construction configuration and has the ability to limit brute-force attacks on the system. RHEL 8 utilizes "pwquality" as a mechanism to enforce password complexity. This is set in both: /etc/pam.d/password-auth /etc/pam.d/system-auth By limiting the number of attempts to meet the pwquality module complexity requirements before returning with an error, the system will audit abnormal attempts at password changes.

Check Content

Note: This requirement applies to RHEL versions 8.4 or newer. If the system is RHEL below version 8.4, this requirement is not applicable. Verify the operating system is configured to limit the "pwquality" retry option to 3. Check for the use of the "pwquality" retry option with the following command: $ sudo grep retry /etc/security/pwquality.conf retry = 3 If the value of "retry" is set to "0" or greater than "3", is commented out or missing, this is a finding. Check for the use of the "pwquality" retry option in the system-auth and password-auth files with the following command: $ sudo grep retry /etc/pam.d/system-auth /etc/pam.d/password-auth If the command returns any results, this is a finding.

Fix Text

Configure the operating system to limit the "pwquality" retry option to 3. Add the following line to the "/etc/security/pwquality.conf" file(or modify the line to have the required value): retry = 3

Additional Identifiers

Rule ID: SV-251716r809372_rule

Vulnerability ID: V-251716

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.