Title

The layer 2 switch must implement Rapid STP where VLANs span multiple switches with redundant links. (Cat II impact)

Discussion

Spanning Tree Protocol (STP) is implemented on bridges and switches to prevent layer 2 loops when a broadcast domain spans multiple bridges and switches and when redundant links are provisioned to provide high availability in case of link failures. Convergence time can be significantly reduced using Rapid STP (802.1w) instead of STP (802.1d), resulting in improved availability. Rapid STP should be deployed by implementing either Rapid Per-VLAN-Spanning-Tree (Rapid-PVST) or Multiple Spanning-Tree Protocol (MSTP), the latter scales much better when there are many VLANs.

Check Content

In cases where VLANs do not span multiple switches, it is a best practice to not implement STP. Avoiding the use of STP will provide the most deterministic and highly available network topology. If STP is required, then review the switch configuration to verify that Rapid STP has been implemented. If Rapid STP has not been implemented where STP is required, this is a finding.

Fix Text

Configure Rapid STP to be implemented at the access and distribution layers where VLANs span multiple switches.

Additional Identifiers

Rule ID: SV-206663r385561_rule

Vulnerability ID: V-206663

Group Title: SRG-NET-000512

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.