Title

The IBM z/VM CA VM:Secure product must be installed and operating. (Cat II impact)

Discussion

If events associated with nonlocal administrative access or diagnostic sessions are not logged, a major tool for assessing and investigating attacks would not be available. This requirement addresses auditing-related issues associated with maintenance tools used specifically for diagnostic and repair actions on organizational information systems. Nonlocal maintenance and diagnostic activities are those activities conducted by individuals communicating through a network, either an external network (e.g., the Internet) or an internal network. Local maintenance and diagnostic activities are those activities carried out by individuals physically present at the information system or information system component and not communicating across a network connection. This requirement applies to hardware/software diagnostic test equipment or tools. This requirement does not cover hardware/software components that may support information system maintenance, yet are a part of the system, for example, the software implementing "ping," "ls," "ipconfig," or the hardware and software implementing the monitoring port of an Ethernet switch.

Check Content

Verify that CA VM:Secure product is operational on the system by entering the following command: From the CMS Command line enter “VMSECURE VERSION”. If there is no response “VMSECURE” is not logged in, this is a finding.

Fix Text

CA VM:Secure product audits all commands. Ensure that CA VM:Secure product is installed and operational.

Additional Identifiers

Rule ID:

Vulnerability ID: IBMZ-VM-001160

Group Title:

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.