Check: CSCO-NM-000230
Cisco ISE NDM STIG:
CSCO-NM-000230
(in versions v2 r3 through v1 r1)
Title
The Cisco ISE must be configured to synchronize internal information system clocks using redundant authoritative time sources. (Cat II impact)
Discussion
The loss of connectivity to a particular authoritative time source will result in the loss of time synchronization (free-run mode) and increasingly inaccurate time stamps on audit events and other functions. Multiple time sources provide redundancy by including a secondary source. Time synchronization is usually a hierarchy; clients synchronize time to a local source while that source synchronizes its time to a more accurate source. The network device must utilize an authoritative time server and/or be configured to use redundant authoritative time sources. This requirement is related to the comparison done in CCI-001891. DOD-approved solutions consist of a combination of a primary and secondary time source using a combination or multiple instances of the following: a time server designated for the appropriate DOD network (NIPRNet/SIPRNet); United States Naval Observatory (USNO) time servers; and/or the Global Positioning System (GPS). The secondary time source must be located in a different geographic region than the primary time source.
Check Content
1. View the status of the Network Translation Protocol (NTP) associations. show ntp 2. Verify a primary and secondary ntp server address is configured. If the Cisco ISE is not configured to synchronize internal information system clocks using redundant authoritative time sources, this is a finding.
Fix Text
1. Choose Administration >> System >> Settings >> System Time. 2. Enter unique IP addresses (IPv4/IPv6/FQDN) for the NTP servers. 3. Configure redundant NTP server addresses. Note: If authentication settings are no longer available, then a DOD-approved solution must be used. Use of MD5 results in a CAT 2 (CSCO-NM-000390) finding since NTP authentication is required. DOD-approved solutions consist of a combination of a primary and secondary time source using a combination or multiple instances of the following: a time server designated for the appropriate DOD network (NIPRNet/SIPRNet); United States Naval Observatory (USNO) time servers; and/or the Global Positioning System (GPS). The secondary time source must be located in a different geographic region than the primary time source.
Additional Identifiers
Rule ID: SV-242629r1168433_rule
Vulnerability ID: V-242629
Group Title: SRG-APP-000373-NDM-000298
Expert Comments
CCIs
| Number | Definition |
|---|---|
| CCI-000366 |
Implement the security configuration settings. |
| CCI-001893 |
The information system identifies a secondary authoritative time source that is located in a different geographic region than the primary authoritative time source. |
| CCI-004922 |
Synchronize system clocks within and between systems or system components. |
| CCI-004928 |
Identify a secondary authoritative time source that is in a different geographic region than the primary authoritative time source. |