Check: CISC-RT-000330
Cisco IOS XE Switch RTR STIG:
CISC-RT-000330
(in versions v2 r5 through v1 r0.1)
Title
The Cisco perimeter switch must be configured to filter ingress traffic at the external interface on an inbound direction. (Cat II impact)
Discussion
Access lists are used to separate data traffic into that which it will route (permitted packets) and that which it will not route (denied packets). Secure configuration of switches makes use of access lists for restricting access to services on the switch itself as well as for filtering traffic passing through the switch. Inbound versus Outbound: It should be noted that some operating systems default access lists are applied to the outbound queue. The more secure solution is to apply the access list to the inbound queue for three reasons: - The switch can protect itself before damage is inflicted. - The input port is still known and can be filtered upon. - It is more efficient to filter packets before routing them.
Check Content
Review the switch configuration to verify that an inbound ACL is configured on all external interfaces as shown in the example below: interface GigabitEthernet0/2 ip address x.11.1.2 255.255.255.254 ip access-group EXTERNAL_ACL_INBOUND in If the switch is not configured to filter traffic entering the network at all external interfaces in an inbound direction, this is a finding.
Fix Text
Configure the switch to use an inbound ACL on all external interfaces as shown in the example below: SW1(config)#int g0/2 SW1(config-if)#ip access-group EXTERNAL_ACL_INBOUND in
Additional Identifiers
Rule ID: SV-221013r622190_rule
Vulnerability ID: V-221013
Group Title: SRG-NET-000205-RTR-000004
Expert Comments
CCIs
Number | Definition |
---|---|
CCI-001097 |
The information system monitors and controls communications at the external boundary of the information system and at key internal boundaries within the system. |
Controls
Number | Title |
---|---|
SC-7 |
Boundary Protection |