Title

The Cisco VPN remote access server must be configured to use AES256 or greater encryption for the Internet Key Exchange (IKE) Phase 1 to protect confidentiality of remote access sessions. (Cat I impact)

Discussion

Without confidentiality protection mechanisms, unauthorized individuals may gain access to sensitive information via a remote access session. Remote access is access to DOD nonpublic information systems by an authorized user (or an information system) communicating through an external, non-organization-controlled network. AES is the FIPS-validated cipher block cryptographic algorithm approved for use in DOD. For an algorithm implementation to be listed on a FIPS 140-2/140-3 cryptographic module validation certificate as an approved security function, the algorithm implementation must meet all the requirements of FIPS 140-2/140-3 and must successfully complete the cryptographic algorithm validation process. Currently, NIST has approved the following confidentiality modes to be used with approved block ciphers in a series of special publications: ECB, CBC, OFB, CFB, CTR, XTS-AES, FF1, FF3, CCM, GCM, KW, KWP, and TKW.

Check Content

Verify IKE Phase 1 is set to use an AES256 or greater encryption algorithm as shown in the example below. crypto ipsec ikev2 ipsec-proposal IPSEC_TRANS protocol esp encryption aes-256 If the value of the encryption algorithm for IKE Phase 1 is not set to use an AES256 or greater algorithm, this is a finding.

Fix Text

Configure the ASA to use AES256 or greater encryption algorithm for IKE Phase 1 as shown in the example below. ASA1(config)# crypto ikev2 policy 1 ASA1(config-ikev2-policy)# encryption aes-256

Additional Identifiers

Rule ID: SV-239979r916140_rule

Vulnerability ID: V-239979

Group Title: SRG-NET-000317-VPN-001090

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.