Title

The system must set strict multihoming. (Cat II impact)

Discussion

These settings control whether a packet arriving on a non-forwarding interface can be accepted for an IP address that is not explicitly configured on that interface. This rule is NA for documented systems that have interfaces that cross strict networking domains (for example, a firewall, a router, or a VPN node).

Check Content

Determine if strict multihoming is configured. # ipadm show-prop -p _strict_dst_multihoming -co current ipv4 # ipadm show-prop -p _strict_dst_multihoming -co current ipv6 If the output of all commands is not "1", this is a finding.

Fix Text

The Network Management profile is required. Disable strict multihoming for IPv4 and IPv6. # pfexec ipadm set-prop -p _strict_dst_multihoming=1 ipv4 # pfexec ipadm set-prop -p _strict_dst_multihoming=1 ipv6

Additional Identifiers

Rule ID: SV-216375r603267_rule

Vulnerability ID: V-216375

Group Title: SRG-OS-000480

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.