Title

The perimeter router must be configured to drop IPv6 packets containing a Destination Option header with invalid option type values. (Cat II impact)

Discussion

These options are intended to be for the Hop-by-Hop header only. The optional and extensible natures of the IPv6 extension headers require higher scrutiny since many implementations do not always drop packets with headers that it cannot recognize. Hence, this could cause a Denial-of-Service on the target device. In addition, the type, length, value (TLV) formatting provides the ability for headers to be very large.

Check Content

This requirement is not applicable for the DODIN Backbone. Review the router configuration and determine if filters are bound to the external interfaces to drop IPv6 packets containing a Destination Option header with option type values of 0x05 (Router Alert) or 0xC2 (Jumbo Payload). Note: Because Hop-by-Hop and destination options have the same exact header format, they are combined under the dest-option-type keyword. According to Cisco, since Hop-by-Hop and Destination Option headers have non-overlapping types, dest-option-type to match either can be used. The Hop-by-Hop and Destination Option headers can be filtered via protocol 0 and 60 respectively. If the router is not configured to drop IPv6 packets containing a Destination Option header with invalid option type values, this is a finding.

Fix Text

Configure the router to drop IPv6 packets containing a Destination Option header with option type values of 0x05 (Router Alert) or 0xC2 (Jumbo Payload).

Additional Identifiers

Rule ID: SV-220150r856669_rule

Vulnerability ID: V-220150

Group Title: SRG-NET-000364

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.