Title

RHEL 9 must protect against or limit the effects of denial-of-service (DoS) attacks by ensuring rate-limiting measures on impacted network interfaces are implemented. (Cat II impact)

Discussion

DoS is a condition when a resource is not available for legitimate users. When this occurs, the organization either cannot accomplish its mission or must operate at degraded capacity. This requirement addresses the configuration of RHEL 9 to mitigate the impact of DoS attacks that have occurred or are ongoing on system availability. For each system, known and potential DoS attacks must be identified and solutions for each type implemented. A variety of technologies exists to limit or, in some cases, eliminate the effects of DoS attacks (e.g., limiting processes or establishing memory partitions). Employing increased capacity and bandwidth, combined with service redundancy, may reduce the susceptibility to some DoS attacks.

Check Content

Verify "nftables" is configured to allow rate limits on any connection to the system with the following command: $ sudo grep -i firewallbackend /etc/firewalld/firewalld.conf # FirewallBackend FirewallBackend=nftables If the "nftables" is not set as the "FirewallBackend" default, this is a finding.

Fix Text

Configure "nftables" to be the default "firewallbackend" for "firewalld" by adding or editing the following line in "etc/firewalld/firewalld.conf": FirewallBackend=nftables Establish rate-limiting rules based on organization-defined types of DoS attacks on impacted network interfaces.

Additional Identifiers

Rule ID: SV-257939r925804_rule

Vulnerability ID: V-257939

Group Title: SRG-OS-000420-GPOS-00186

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.