Title

RHEL 9 must not send Internet Control Message Protocol (ICMP) redirects. (Cat II impact)

Discussion

ICMP redirect messages are used by routers to inform hosts that a more direct route exists for a particular destination. These messages contain information from the system's route table possibly revealing portions of the network topology. The ability to send ICMP redirects is only appropriate for systems acting as routers.

Check Content

Verify RHEL 9 does not IPv4 ICMP redirect messages. Check the value of the "all send_redirects" variables with the following command: $ sysctl net.ipv4.conf.all.send_redirects net.ipv4.conf.all.send_redirects = 0 If the returned line does not have a value of "0", or a line is not returned, this is a finding. Check that the configuration files are present to enable this network parameter. $ sudo /usr/lib/systemd/systemd-sysctl --cat-config | egrep -v '^(#|;)' | grep -F net.ipv4.conf.all.send_redirects | tail -1 net.ipv4.conf.all.send_redirects = 0 If "net.ipv4.conf.all.send_redirects" is not set to "0" and is not documented with the information system security officer (ISSO) as an operational requirement or is missing, this is a finding.

Fix Text

Configure RHEL 9 to not allow interfaces to perform IPv4 ICMP redirects. Add or edit the following line in a single system configuration file, in the "/etc/sysctl.d/" directory: net.ipv4.conf.all.send_redirects = 0 Load settings from all system configuration files with the following command: $ sudo sysctl --system

Additional Identifiers

Rule ID: SV-257968r925891_rule

Vulnerability ID: V-257968

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.