Title

RHEL 9 must use a reverse-path filter for IPv4 network traffic when possible by default. (Cat II impact)

Discussion

Enabling reverse path filtering drops packets with source addresses that should not have been able to be received on the interface on which they were received. It must not be used on systems that are routers for complicated networks, but is helpful for end hosts and routers serving small networks.

Check Content

Verify RHEL 9 uses reverse path filtering on IPv4 interfaces with the following commands: $ sudo sysctl net.ipv4.conf.default.rp_filter net.ipv4.conf.default.rp_filter = 1 If the returned line does not have a value of "1", or a line is not returned, this is a finding. Check that the configuration files are present to enable this network parameter. $ sudo /usr/lib/systemd/systemd-sysctl --cat-config | egrep -v '^(#|;)' | grep -F net.ipv4.conf.default.rp_filter | tail -1 net.ipv4.conf.default.rp_filter = 1 If "net.ipv4.conf.default.rp_filter" is not set to "1" or is missing, this is a finding.

Fix Text

Configure RHEL 9 to use reverse path filtering on IPv4 interfaces by default. Add or edit the following line in a single system configuration file, in the "/etc/sysctl.d/" directory: net.ipv4.conf.default.rp_filter = 1 Load settings from all system configuration files with the following command: $ sudo sysctl --system

Additional Identifiers

Rule ID: SV-257965r925882_rule

Vulnerability ID: V-257965

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.