Title

RHEL 9 must not forward IPv4 source-routed packets by default. (Cat II impact)

Discussion

Source-routed packets allow the source of the packet to suggest routers forward the packet along a different path than configured on the router, which can be used to bypass network security measures. Accepting source-routed packets in the IPv4 protocol has few legitimate uses. It must be disabled unless it is absolutely required, such as when IPv4 forwarding is enabled and the system is legitimately functioning as a router.

Check Content

Verify RHEL 9 does not accept IPv4 source-routed packets by default. Check the value of the accept source route variable with the following command: $ sysctl net.ipv4.conf.default.accept_source_route net.ipv4.conf.default.accept_source_route = 0 If the returned line does not have a value of "0", a line is not returned, or the line is commented out, this is a finding. Check that the configuration files are present to enable this network parameter. $ sudo /usr/lib/systemd/systemd-sysctl --cat-config | egrep -v '^(#|;)' | grep -F net.ipv4.conf.default.accept_source_route | tail -1 net.ipv4.conf.default.accept_source_route = 0 If "net.ipv4.conf.default.accept_source_route" is not set to "0" or is missing, this is a finding.

Fix Text

Configure RHEL 9 to not forward IPv4 source-routed packets by default. Add or edit the following line in a single system configuration file, in the "/etc/sysctl.d/" directory: net.ipv4.conf.default.accept_source_route = 0 Load settings from all system configuration files with the following command: $ sudo sysctl --system

Additional Identifiers

Rule ID: SV-257964r925879_rule

Vulnerability ID: V-257964

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.