Check: RHEL-09-254035
RHEL 9 STIG:
RHEL-09-254035
(in version v1 r1)
Title
RHEL 9 must prevent IPv6 Internet Control Message Protocol (ICMP) redirect messages from being accepted. (Cat II impact)
Discussion
ICMP redirect messages are used by routers to inform hosts that a more direct route exists for a particular destination. These messages modify the host's route table and are unauthenticated. An illicit ICMP redirect message could result in a man-in-the-middle attack.
Check Content
Verify RHEL 9 will not accept IPv6 ICMP redirect messages. Note: If IPv6 is disabled on the system, this requirement is Not Applicable. Check the value of the default "accept_redirects" variables with the following command: $ sysctl net.ipv6.conf.default.accept_redirects net.ipv6.conf.default.accept_redirects = 0 If the returned line does not have a value of "0", a line is not returned, or the line is commented out, this is a finding. Check that the configuration files are present to enable this network parameter. $ sudo /usr/lib/systemd/systemd-sysctl --cat-config | egrep -v '^(#|;)' | grep -F net.ipv6.conf.default.accept_redirects | tail -1 net.ipv6.conf.default.accept_redirects = 0 If "net.ipv6.conf.default.accept_redirects" is not set to "0" or is missing, this is a finding.
Fix Text
Configure RHEL 9 to prevent IPv6 ICMP redirect messages from being accepted. Add or edit the following line in a single system configuration file, in the "/etc/sysctl.d/" directory: net.ipv6.conf.default.accept_redirects = 0 Load settings from all system configuration files with the following command: $ sudo sysctl --system
Additional Identifiers
Rule ID: SV-257976r925915_rule
Vulnerability ID: V-257976
Group Title: SRG-OS-000480-GPOS-00227
Expert Comments
CCIs
Number | Definition |
---|---|
CCI-000366 |
The organization implements the security configuration settings. |
Controls
Number | Title |
---|---|
CM-6 |
Configuration Settings |