Title

RHEL 8 systems below version 8.4 must ensure the password complexity module in the password-auth file is configured for three retries or less. (Cat II impact)

Discussion

Use of a complex password helps to increase the time and resources required to compromise the password. Password complexity, or strength, is a measure of the effectiveness of a password in resisting attempts at guessing and brute-force attacks. "pwquality" enforces complex password construction configuration and has the ability to limit brute-force attacks on the system. RHEL 8 uses "pwquality" as a mechanism to enforce password complexity. This is set in both: /etc/pam.d/password-auth /etc/pam.d/system-auth By limiting the number of attempts to meet the pwquality module complexity requirements before returning with an error, the system will audit abnormal attempts at password changes.

Check Content

Note: This requirement applies to RHEL versions 8.0 through 8.3. If the system is RHEL version 8.4 or newer, this requirement is not applicable. Verify the operating system is configured to limit the "pwquality" retry option to 3. Check for the use of the "pwquality" retry option in the password-auth file with the following command: $ sudo cat /etc/pam.d/password-auth | grep pam_pwquality password requisite pam_pwquality.so retry=3 If the value of "retry" is set to "0" or greater than "3", this is a finding.

Fix Text

Configure the operating system to limit the "pwquality" retry option to 3. Add the following line to the "/etc/pam.d/password-auth" file (or modify the line to have the required value): password requisite pam_pwquality.so retry=3

Additional Identifiers

Rule ID: SV-251715r1017368_rule

Vulnerability ID: V-251715

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.