Title

RHEL 8 must disable the asynchronous transfer mode (ATM) protocol. (Cat III impact)

Discussion

It is detrimental for operating systems to provide, or install by default, functionality exceeding requirements or mission objectives. These unnecessary capabilities or services are often overlooked and therefore may remain unsecured. They increase the risk to the platform by providing additional attack vectors. Failing to disconnect unused protocols can result in a system compromise. The Asynchronous Transfer Mode (ATM) is a protocol operating on network, data link, and physical layers, based on virtual circuits and virtual paths. Disabling ATM protects the system against exploitation of any laws in its implementation.

Check Content

Verify the operating system disables the ability to load the ATM protocol kernel module. $ sudo grep -r atm /etc/modprobe.d/* | grep "/bin/false" install atm /bin/false If the command does not return any output, or the line is commented out, and use of the ATM protocol is not documented with the Information System Security Officer (ISSO) as an operational requirement, this is a finding. Verify the operating system disables the ability to use the ATM protocol. Check to see if the ATM protocol is disabled with the following command: $ sudo grep -r atm /etc/modprobe.d/* | grep "blacklist" blacklist atm If the command does not return any output or the output is not "blacklist atm", and use of the ATM protocol is not documented with the ISSO as an operational requirement, this is a finding.

Fix Text

Configure the operating system to disable the ability to use the ATM protocol kernel module. Add or update the following lines in the file "/etc/modprobe.d/blacklist.conf": install atm /bin/false blacklist atm Reboot the system for the settings to take effect.

Additional Identifiers

Rule ID: SV-230494r942918_rule

Vulnerability ID: V-230494

Group Title: SRG-OS-000095-GPOS-00049

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.