Title

RHEL 8 must define default permissions for logon and non-logon shells. (Cat II impact)

Discussion

The umask controls the default access mode assigned to newly created files. A umask of 077 limits new files to mode 600 or less permissive. Although umask can be represented as a four-digit number, the first digit representing special access modes is typically ignored or required to be "0". This requirement applies to the globally configured system defaults and the local interactive user defaults for each account on the system.

Check Content

Verify that the umask default for installed shells is "077". Check for the value of the "UMASK" parameter in the "/etc/bashrc", "/etc/csh.cshrc" and "/etc/profile" files with the following command: Note: If the value of the "UMASK" parameter is set to "000" in the "/etc/bashrc" the "/etc/csh.cshrc" or the "/etc/profile" files, the Severity is raised to a CAT I. # grep -i umask /etc/bashrc /etc/csh.cshrc /etc/profile /etc/bashrc: umask 077 /etc/bashrc: umask 077 /etc/csh.cshrc: umask 077 /etc/csh.cshrc: umask 077 /etc/profile: umask 077 /etc/profile: umask 077 If the value for the "UMASK" parameter is not "077", or the "UMASK" parameter is missing or is commented out, this is a finding.

Fix Text

Configure the operating system to define default permissions for all authenticated users in such a way that the user can only read and modify their own files. Add or edit the lines for the "UMASK" parameter in the "/etc/bashrc", "/etc/csh.cshrc" and "/etc/profile"files to "077": UMASK 077

Additional Identifiers

Rule ID: SV-230385r1017194_rule

Vulnerability ID: V-230385

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.