Title

The Juniper multicast Designated Router (DR) must be configured to limit the number of mroute states resulting from Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Host Membership Reports. (Cat II impact)

Discussion

The current multicast paradigm can let any host join any multicast group at any time by sending an IGMP or MLD membership report to the DR. In a Protocol Independent Multicast (PIM) Sparse Mode network, the DR will send a PIM Join message for the group to the RP. Without any form of admission control, this can pose a security risk to the entire multicast domain - specifically the multicast routers along the shared tree from the DR to the RP that must maintain the mroute state information for each group join request. Hence, it is imperative that the DR is configured to limit the number of mroute state information that must be maintained to mitigate the risk of IGMP or MLD flooding.

Check Content

Review the DR configuration to verify that it is limiting the number of mroute states via IGMP or MLD. protocols { igmp { interface ge-1/0/1.0 { group-limit nnn; } } If the DR is not limiting multicast join requests via IGMP or MLD, this is a finding.

Fix Text

Configure the DR on a global or interface basis to limit the number of mroute states resulting from IGMP or MLD membership reports. [edit protocols igmp] set interface ge-1/0/1.0 group-limit nnn

Additional Identifiers

Rule ID: SV-217091r604135_rule

Vulnerability ID: V-217091

Group Title: SRG-NET-000362-RTR-000122

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.