Title

AIX must employ a deny-all, allow-by-exception firewall policy for allowing connections to other systems. (Cat II impact)

Discussion

Failure to restrict network connectivity only to authorized systems permits inbound connections from malicious systems. It also permits outbound connections that may facilitate exfiltration of DoD data.

Check Content

From the command prompt, run the following commands to check if the "all traffic" filter rules, the predefined rule with Rule-ID 0, are defined to deny all packages: # lsfilt -v4 -n0 # lsfilt -v6 -n0 Rule 0: Rule action : deny Source Address : 0.0.0.0 Source Mask : 0.0.0.0 Destination Address : 0.0.0.0 Destination Mask : 0.0.0.0 Source Routing : yes Protocol : all Source Port : any 0 Destination Port : any 0 Scope : both Direction : both Logging control : no Fragment control : all packets Tunnel ID number : 0 Interface : all Auto-Generated : no Expiration Time : 0 Description : Default Rule Rule 0: Rule action : deny Source Address : :: Source Mask : 0 Destination Address : :: Destination Mask : 0 Source Routing : yes Protocol : all Source Port : any 0 Destination Port : any 0 Scope : both Direction : both Logging control : no Fragment control : all packets Tunnel ID number : 0 Interface : all Auto-Generated : no Expiration Time : 0 Description : Default Rule If any of the "all traffic" rules has "Rule action : permit", this is a finding.

Fix Text

From the command prompt, run the following commands to create and activate "ipsec_v4" and "ipsec_v6" devices: # mkdev -l ipsec -t 4 # mkdev -l ipsec -t 6 From the command prompt, run the following commands to change the "all traffic" rules to block all packages: # chfilt -a D -v 4 -n 0 # chfilt -a D -v 6 -n 0 Assume that the local host has IP address 10.10.10.10 and the remote host has IP address 11.11.11.11, run the following command to generate a user-defined filter rule that allow all IPv4 traffic between these 2 hosts: # genfilt -w B -v 4 -s 10.10.10.10 -p 0 -P 0 -o any -O any -m 255.255.255.255 -M 255.255.255.255 -i all -g Y -d 11.11.11.11 -c all -a P From the command prompt, run the following command to activate all the filter rules in the rule database: # mkfilt -u

Additional Identifiers

Rule ID: SV-219057r853494_rule

Vulnerability ID: V-219057

Group Title: SRG-OS-000480-GPOS-00227

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.