Title

Forescout must deny or restrict access for endpoints that fail critical endpoint security checks. This is required for compliance with C2C Step 4. (Cat II impact)

Discussion

Devices that do not meet minimum-security configuration requirements pose a risk to the DoD network and information assets. Endpoint devices must be disconnected or given limited access as designated by the approval authority and system owner if the device fails the authentication or security assessment. The user will be presented with a limited portal, which does not include access options for sensitive resources. Required security checks must implement DoD policy requirements.

Check Content

If DoD is not at C2C Step 4 or higher, this is not a finding. Verify Forescout has been configured to redirect filtered devices to a limited access network to include a remediation network or limited access network. If a policy does not exist that redirects the failed device to an authorized network for remediation or limited access, this is not a finding. If the NAC does not deny or restrict access for endpoints that fail critical endpoint security checks, this is a finding.

Fix Text

Use the Forescout Administrator UI to configure any pre-connect policies to ensure endpoints that fail the baseline security configuration requirements are set to either restrict access or isolate the endpoint. 1. Log on to the Forescout UI. 2. From the Policy tab, check any Pre-Connect policies to ensure devices that fail the baseline security configuration requirements are set to either restrict access to production network, are granted access to only remediation network, or are granted to a limited access network.

Additional Identifiers

Rule ID: SV-233322r856508_rule

Vulnerability ID: V-233322

Group Title: SRG-NET-000322-NAC-001230

Expert Comments

CCIs tied to check.

Controls tied to check. These are derived from the CCIs shown above.