Check: CISC-RT-000370
Cisco IOS XE Router RTR STIG:
CISC-RT-000370
(in versions v2 r9 through v1 r1)
Title
The Cisco perimeter router must be configured to have Cisco Discovery Protocol (CDP) disabled on all external interfaces. (Cat III impact)
Discussion
CDP is a Cisco proprietary neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. CDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing CDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.
Check Content
This requirement is not applicable for the DODIN Backbone. Step 1: Verify if CDP is enabled globally as shown below: cdp run By default, CDP is not enabled globally or on any interface. If CDP is enabled globally, proceed to step 2. Step 2: Verify CDP is not enabled on any external interface as shown in the example below: interface GigabitEthernet2 ip address z.1.24.4 255.255.255.252 … … … cdp enable If CDP is enabled on any external interface, this is a finding.
Fix Text
This requirement is not applicable for the DODIN Backbone. Disable CDP on all external interfaces via no cdp enable command or disable CDP globally via no cdp run command.
Additional Identifiers
Rule ID: SV-216675r855822_rule
Vulnerability ID: V-216675
Group Title: SRG-NET-000364-RTR-000111
Expert Comments
CCIs
Number | Definition |
---|---|
CCI-002403 |
The information system only allows incoming communications from organization-defined authorized sources routed to organization-defined authorized destinations. |
Controls
Number | Title |
---|---|
SC-7 (11) |
Restrict Incoming Communications Traffic |